2. Print the image. Is the problem resolved?
Yes Finished! If the problem also occurs on side 2 of the paper, perform the solution described
in "(b) If the problem occurs on side 2".
No Decrease the absolute value of the negative current by another 5 A.
3. Repeat Step 2. If the image is lighter in density but the problem persists, reset the current
to the original value and go to Step 4.
4. Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use,
decrease the absolute value by 5 A in 1202: [Image Transfer Output].
Example: If the present current is 80 A, change it to 75 A.
5. Print the image. Is the problem resolved?
Yes Finished!
No Decrease the absolute value of the negative current by another 5 A.
6. Repeat Step 5. If the image is lighter in density but the problem persists, contact your
service representative.
(b) If the problem occurs on side 2
1. Adjust the setting for the side 2 of the paper. Select [Machine: Image Quality] in
[Advanced Settings] for the custom paper in use, decrease the absolute value of [Side 2]
by 5 A in 1203: [Paper Transfer Output].
Example: If the present current is −100 A, change it to −95 A.
2. Print the image. Is the problem resolved?
Yes Finished!
No Decrease the absolute value of the negative current by another 5 A.
3. Repeat Step 2. If the image is lighter in density but the problem persists, contact your
service representative.
Blister-like White Spots
White spots 0.3–0.5 mm (0.01–0.02 inches) in diameter surrounded by denser spots (blister-like white
spots) appear.
3. Troubleshooting Image Quality Problems
38
To Next Page
Loading...
Need help?
General
