Paper of Paper Weight 0 is being used.
If limp paper such as thin paper is being used, set the finisher upper tray to the paper output
tray.
If paper is not loaded correctly even if the finisher upper tray is being used, attach the support
tray.
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
<If the decurler unit is used>
• In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for
Operators] menu, set 0310: [Correct Output Paper Curl] to "П Curl Correction
Level".
To control the level of decurling, select "Small" if the present setting is "Off" or
"Large" if the present value is "Small".
• Attach the output jogger.
<If the decurler unit is not used>
• Set the reverse side of the paper.
• Attach the output jogger.
Trailing edge of stapled sheets close to the paper exit
Cause:
If the stapled sheets are curled strongly or become limp after delivery, the trailing edge of the sheets
may be too close to the paper exit when the paper is stacked.
If this happens, stapled sheets, when delivered, may push the previously delivered sheet, resulting in
paper bending or misfeeding.
This is likely to occur if:
5. Post-Processing Option Troubleshooting
138
To Next Page
Loading...
Need help?
General
