Sony MVS-6530 User Manual

USO RESTRITO
340
Operation Settings
1
Open the Engineering Setup >Panel >Device Interface
>Serial Port Assign menu (7325.5).
2
In the list on the left, select the port for the setting.
3
In the list on the right, select the device type.
Notes
The following device types can be selected for the
Remote1 to Remote4 ports on the rear panel of the
switcher.
• DDR SD9P (Sony disk 9-pin protocol)
Chapter
18
Control
Panel
Setup
Setting the Serial Ports
This sets the Remote1 to Remote4 ports on the rear panel
of the switcher.
• Mixer ESAM-II
• AS ES-BUS
4 Press [Device Type Set].
5 To attach a name to the selected port, push [Set] in the
<Assign> group and enter a port name in the keyboard
window.
6 To display detail information about the selected port,
press [Port Setting].
For details about [Port Setting], 1 “Making Detailed
Settings on the External Device Connected to the
Serial Port” (p. 369).
Setting the AUX Bus Override
Operating Mode
Set the operating mode when the trigger type is “Rising
Edge” or “Falling Edge,” and “Aux ? O'ride Src ??” is
selected as the GPI input action.
In the <Aux Bus Override Mode> group of the
Engineering Setup >Panel >Device Interface menu (7325),
select one of the following modes.
Momentary: On an input pulse rising (falling) edge, the
input of the selected AUX bus is used, and on a falling
(rising) edge this returns to the original cross-point.
Latch: On an input pulse rising (falling) edge, the input of
the selected AUX bus is used, and this does not return
to the original cross-point change even on a falling
(rising) edge.
This setting is also valid when AUX bus override is
selected as the DCU GPI input ( 1 p. 366).
Operation Settings
Setting the On-Air Tally
To set the high tally state reflected on the control panel, use
the following procedure.
1 Open the Engineering Setup >Panel >Operation
>Button Tally menu (7326.9).
2 In the <Tally Type> group, select either of the
following.
[R1] to [R8]: Reflect the tally state of the tally group
(1 to 8).
Independ: Reflects the tally state of the switcher only.
3 Press [Execute].
Assigning a Bus or Function to 1st
Row Buttons
Assigns keys AUX bus, and other functions that are
selectable in the 1st row of the cross-point control block.
1 Open the Engineering Setup >Panel >Operation >Key/
AUX/Function Assign menu (7326.13).
2 In the list on the left, select the button.
3 Select the bus or function you want to assign from the
list on the right.
4 Press [Set].
Setting the Transition Rate Display
Mode
To determine whether to display transition rate values in
menus and on the control panel in frames or as timecode
values, select either of the following in the <Trans Rate
Display> group.
Frame: Displays in frames.
Timecode: Display as timecode (SS:FF).

Sony MVS-6530 Specifications

General

BNC input ports	48
BNC output ports	32
RJ-45 input ports	4
Product color	Black
AC input voltage	100 - 240 V
AC adapter frequency	50/60 Hz
AC adapter input current	4 A
Storage temperature (T-T)	-20 - 55 °C
Operating temperature (T-T)	5 - 40 °C

Weight and Dimensions

Depth	486 mm
Width	482 mm
Height	176 mm
Weight	21000 g