Data Saved by [Setup Define] and [Initial Status Define] 433
Data Saved by [Initial Status Define]
Included in Panel
• Settings for the following cross-point control block buttons
- Delegation buttons assigned to the 1st row
- [1ST ROW DSPLY], [2ND ROW DSPLY], [SHIFT], [MCRO ATTCH
ENBL]
• Transition control block: [KF], [SHIFT], and independent key transition
[KEY1] to [KEY4] buttons
• Flexi Pad: Settings for the [WIPE], [DME WIPE], [SNAPSHOT], [EFF],
[SHOTBOX], [MCRO], [TRNS RATE], [KEY ADJ], [KEY SS] buttons
• Settings for “System Manager Enbl” assigned to user preference
button on the menu panel
Misc >Enable >Port Enable
[System Manager] settings
Snapshot >Key Snapshot >Attribute
Settings of <Recall Mode> group
Included in Switcher (Same as data saved in Snapshots)
• For each M/E, setting data relating to the following:
cross-points, transitions, Key1 to Key4 (including independent key
transition settings), wipes, DME wipes
• Color backgrounds 1/2
• Frame memory
• AUX bus (including CCR, AUX mix transition settings)
Misc >Enable >Port Enable
Setting data for <Switcher> group
All data relating to Side Flags menu
Included in DME
Three-dimensional transformation data
All data relating to Border/Crop menu
All data relating to Beveled Edge menu
All data relating to Video Modify menu
All data relating to Freeze menu
DME >Non Linear/Corner Pin >Non
Linear
All data relating to Non Linear menu
DME >Light/Trail >Lighting
All data relating to Lighting menu
All data relating to Trail menu
DME >Light/Trail >Motion Decay
All data relating to Motion Decay menu
DME >Light/Trail >KF Strobe
All data relating to KF Strobe menu
All data relating to Bkgd menu
DME >Input/Output >Video/Key
All data relating to Video/Key menu
DME >Input/Output >Process
All data relating to Process menu
DME >Input/Output >Graphic
All data relating to Graphic menu