5 — Cycle and Control Value Programming
111
10432589_G AMSCO® 7000 Series
Operator Manual
5.9 Units Menu
To set chemical injection, temperature and pressure units, access Units screen as follows:
1. Access Supervisor mode as explained in Section 5.2, Supervisor Mode Menus. Display shows Supervisor mode
screen:
2. Press Right arrow on touch screen to access following supervisor mode menu:
3. Press Units on Supervisor mode screen. Display shows Units screen:
4. Follow instructions on touch screen to set injection units (oz/gal or mL/L), temperature units (°F or °C), pressure
units (psig, Bar, Kpa) and/or conductivity units (µS/cm or µmho/cm).
To Next Page
Loading...
Need help?
General
