6 — Routine Maintenance
137
10432589_G AMSCO® 7000 Series
Operator Manual
6.6 Cleaning Washer/Disinfector Exterior
WARNING
SLIPPING HAZARD
To prevent slips, keep floors dry. Promptly clean up any spills or drippage. For spills or
drippage of detergents or other chemicals, follow safety precautions and handling
procedures set forth on detergent or chemical label and/or Safety Data Sheet (SDS)
CAUTION
POSSIBLE EQUIPMENT DAMAGE
● Use nonabrasive cleaners when cleaning unit. Follow directions on containers and rub
in a back-and-forth motion (in same direction as surface grain). Abrasive cleaners will
damage stainless steel. Cleaners rubbed in a circular motion or applied with a wire
brush or steel wool on door and chamber assemblies can be harmful to stainless
steel. Do not use these cleaners on painted surfaces.
● Wipe all plastic surfaces or painted surfaces with 70% isopropyl alcohol cleaner (such
as glass or countertop cleaners).
The following cleaning procedure should be performed once per week:
Clean washer/disinfector exterior using a general purpose cleaner (nonabrasive) for general stains, a stainless-steel
stain remover for stubborn stains and a stainless-steel polish to keep equipment looking like new. Proceed as follows:
1. Using a damp cloth or sponge, apply cleaner in a back-and-forth motion, rubbing in same direction as surface
grain.
2. Thoroughly wipe off cleaner.
3. Polish surface with a clean, dry, lint-free cloth.
To Next Page
Loading...
Need help?
General
