7 — Troubleshooting
164
Operator Manual
AMSCO® 7000 Series 10432589_G
Troubleshooting
7.1 Troubleshooting — Introduction
IMPORTANT: A listing of the Safety Precautions to be observed when operating and servicing this equipment can be found in
Safety Precautions section of this manual. Do not operate or service the equipment until you have become familiar with this
information.
7.2 Troubleshooting — General
WARNING
PERSONAL INJURY HAZARD AND/OR EQUIPMENT DAMAGE HAZARD
Repairs and adjustments to this equipment must be made only by STERIS or STERIS-
trained service personnel. Repairs and adjustments performed by unqualified personnel
or installation of unauthorized parts could cause personal injury, result in improper
equipment performance, void the warranty or result in costly damage. Contact STERIS
regarding service options.
WARNING
ELECTRIC SHOCK AND/OR BURN HAZARD
● Repairs and adjustments to this equipment must be made only by STERIS or STERIS-
trained service personnel. Service personnel must disconnect all utilities to unit
before servicing. No one should service unit unless all utilities have been properly
locked out. Always follow local electrical codes and safety-related work practices.
● Fasteners and star washers are used to ensure protective bonding continuity. Always
reinstall any star washer which may have been removed during installation or
servicing.
WARNING
SLIPPING HAZARD
To prevent slips, keep floors dry. Promptly clean up any spills or drippage. For spills or
drippage of detergents or other chemicals, follow safety precautions and handling
procedures set forth on detergent or chemical label and/or Safety Data Sheet (SDS).
This section describes the messages which may appear on the washer/disinfector touch screens and indicates probable
causes.
To Next Page
Loading...
Need help?
General
