EasyManuals Logo
Home>Suzuki>Scooter>Burgman UH125

Suzuki Burgman UH125 Service Manual

Suzuki Burgman UH125
357 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #143 background imageLoading...
Page #143 background image
4-28 FI SYSTEM DIAGNOSIS
MALFUNCTION CODE AND DEFECTIVE CONDITION
DTC No.
DETECTED
ITEM
DETECTED FAILURE CONDITION CHECK FOR
00 NO FAULT
––––––––––– –––––––––––
12
CKP sensor The signal does not reach ECM for 3
sec. or more, after receiving the starter
signal.
CKP sensor wiring and mechan-
ical parts
CKP sensor, lead wire/coupler
connection
P0335
13
IAP sensor The sensor should produce following
voltage.
0.5 V sensor voltage < 4.85 V
In other than the above range, 13
(P0105) is indicated.
IAP sensor, lead wire/coupler
connection
P0105
H
Sensor voltage is higher than specified
value.
IAP sensor circuit open or
shorted to VCC or ground circuit
open
L
Sensor voltage is lower than specified
value.
IAP sensor circuit shorted to
ground or VCC circuit open
14
TP sensor The sensor should produce following
voltage.
0.2 V sensor voltage < 4.80 V
In other than the above range, 14
(P0120) is indicated.
TP sensor, lead wire/coupler
connection
P0120
H
Sensor voltage is higher than specified
value.
TP sensor circuit shorted to
VCC or ground circuit open
L
Sensor voltage is lower than specified
value.
TP sensor circuit open or
shorted to ground or VCC circuit
open
15
ECT sensor The sensor voltage should be the fol-
lowing.
0.15 V sensor voltage < 4.85 V
In other than the above range, 15
(P0115) is indicated.
ECT sensor, lead wire/coupler
connection
P0115
H
Sensor voltage is higher than specified
value.
ECT sensor circuit open or
ground circuit open
L
Sensor voltage is lower than specified
value.
ECT sensor circuit shorted to
ground
23
TO sensor The sensor voltage should be the fol-
lowing for 2 sec. and more, after igni-
tion switch is turned ON.
0.2 V sensor voltage < 4.7 V
In other than the above value, 23
(P1651) is indicated.
TO sensor, lead wire/coupler
connection
P1651
H
Sensor voltage is higher than specified
value.
TO sensor circuit shorted to
VCC or ground circuit open
L
Sensor voltage is lower than specified
value.
TO sensor circuit open or
shorted to ground or VCC circuit
open

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki Burgman UH125 and is the answer not in the manual?

Suzuki Burgman UH125 Specifications

General IconGeneral
BrandSuzuki
ModelBurgman UH125
CategoryScooter
LanguageEnglish

Related product manuals