ELECTRICAL SYSTEM 9-17
STARTER MOTOR REASSEMBLY
Reassemble the starter motor in the reverse order of disassem-
bly. Pay attention to the following points:
• Apply grease to the bearing and lip of oil seal.
. 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Apply a little SUZUKI MOLY PASTE to the armature shaft
end.
/ 99000-25140: SUZUKI MOLY PASTE or equivalent
#
• Apply grease to the O-ring.
. 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
•Fit the washer
1 to the housing end with the tabs aligned with
the housing end cutaways, position the shim
2 and assemble
the starter motor.
• Align the mark
A on the case with the lines
B on the housing
end.
• Fit the O-rings
3 to the starter motor housing bolts and
tighten them.
To prevent oil or water from entering into the motor
inside, the O-rings must be replaced with new ones.
To Next Page
Loading...
Need help?
General
