3-56 ENGINE
ENGINE REASSEMBLY
Reassembly is in the reverse order of removal. Pay attention to the following points:
#
CRANKSHAFT
• Using the special tools, install the crankshaft into the left
crankcase.
NOTE:
When installing in the crankshaft into the crankcase, insert the
attachments

A ((35 mm) and

B ((30 mm) of the bearing
installer set between the crankcase bearing inner lace and
crankshaft installer.
$ 09910-32812: Crankshaft installer
09910-32840: Attachment
09913-70210: Bearing installer set (30 mm, 35 mm)
#
• Using the special tool, press in the oil seal

1 to the position

A where is 1 mm deeper from the crankcase edge.
$ 09913-70210: Bearing installer set
#

A: 1 mm
* Make sure to coat the rotating and sliding sections with engine oil.
* Care must be taken so that the drive V-belt, drive face and driven face are completely free
from oil and grease.
* Do not hit the crankshaft with a plastic mallet or the
like to install it into the crankcase.
* Make sure that the direction of conrod is turned
toward the cylinder hole.
Use new oil seal.
To Next Page
Loading...
Need help?
General
