COOLING AND LUBRICATION SYSTEM 7-5
DISASSEMBLY
• Remove the cooling fan

1.
• Remove the cooling fan thermo-switch

2.
RADIATOR INSPECTION AND CLEANING
• Check the radiator for dirt or small bug stuck between the fins.
• Use compressed air for cleaning. If dirt is excessive, wash
with water.
• Fins bent or dented can be straightened using a small plane
screwdriver.
REASSEMBLY AND INSTALLATION
Reassembly and installation is in the reverse order of removal
and disassembly. Pay attention to the following points:
COOLING FAN
• Install the cooling fan

1.
• Tighten the cooling fan mounting bolts to the specified torque.
% Cooling fan mounting bolt: 8.4 N·m (0.84 kgf-m)
COOLING FAN THERMO-SWITCH
• Fit the O-ring

2 to the cooling fan thermo-switch

3.
• Tighten the cooling fan thermo-switch

3 to the specified
torque.
% Cooling fan thermo-switch: 12 N·m (1.2 kgf-m)
!
* Replace the O-ring with a new one.
* Do not coat grease to the O-ring.
To Next Page
Loading...
Need help?
General
