8-50 CHASSIS
REAR BRAKE MASTER CYLINDER
REASSEMBLY AND INSTALLATION
Reassemble and install the rear brake master cylinder in the
same manner as the front one. ("8-44)
DELAY VALVE REMOVAL
• Drain brake fluid from the combination brake system.
("2-16)
• Remove the front leg shield. ("8-6)
• Remove the lower meter panel.
• Remove the brake pipe joint bolt

1.
• Remove the union bolts

2.
• Remove the delay valve mounting bolts

3.
DELAY VALVE INSTALLATION
Install the delay valve in the reverse order of removal.
Pay attention to the following points:
• Tighten the delay valve mounting bolt

1 securely.
• With the brake hose end contacted to the stopper, tighten the
brake hose union bolt

2 to the specified torque.
$ Brake hose union bolt: 23 N·m (2.3 kgf-m)
• Tighten the brake pipe joint bolt

3 to the specified torque.
$ Brake pipe joint bolt: 16 N·m (1.6 kgf-m)
To Next Page
Loading...
Need help?
General
