ELECTRICAL SYSTEM 9-31
BULB REPLACEMENT
HEADLIGHT
• Remove the front leg shield. (!8-6)
• Remove the headlight bulb terminals

1 and rubber boot

2.
• Remove the headlight bulb by unhooking the bulb holder
spring

3.
• Install new bulb and reassemble the headlight in the reverse
order of the above procedure.
0
#
POSITION LIGHT
• Remove the front leg shield. (!8-6)
• Turn the socket counterclockwise and remove it.
• Replace the bulb with a new one.
• Reinstall the socket and front leg shield in the reverse order of
removal.
The headlight uses a halogen bulb which operates at a
high temperature. Therefore, handle the bulb after suf-
ficiently cooled.
* A fouled glass can cause damage to the bulb when
lit. If the bulb is contacted with bare hand, wipe clean
with a cloth damped with alcohol or detergent.
* Do not use the bulb of a wattage other than specifi-
cation.
To Next Page
Loading...
Need help?
General
