COOLING AND LUBRICATION SYSTEM 7-15
INSPECTION
MECHANICAL SEAL
• Visually inspect the mechanical seal for damage, with particu-
lar attention given to the sealing face.
• Replace the mechanical seal that shows indications of leak-
age. Also replace the seal ring if necessary.
OIL SEAL
• Visually inspect the oil seal for damage, with particular atten-
tion given to the lip.
• Replace the oil seal that shows indications of leakage.
REASSEMBLY AND INSTALLATION
Reassembly and installation is in the reverse order of removal
and disassembly. Pay attention to the following points:
• Install the bearing with the special tool.
& 09913-70210: Bearing installer set (25 mm)
• Install the oil seal with the special tool.
& 09913-70210: Bearing installer set (22 mm)
NOTE:
The stamped mark on the oil seal faces mechanical seal side.
• Apply a small quantity of grease to the oil seal lip.
( 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
To Next Page
Loading...
Need help?
General
