FI SYSTEM AND INTAKE AIR SYSTEM 4-81
SENSORS
IAP SENSOR INSPECTION
The intake air pressure sensor is located at the rear side of the
air cleaner box. ( 4-36)
IAP SENSOR REMOVAL/INSTALLATION
• Lift and support the fuel tank. ( 4-51)
• Remove the IAP sensor mounting screw 1 and disconnect the
coupler 2 and vacuum hose 3.
• Installation is in the reverse order of removal.
TP SENSOR INSPECTION
The throttle position sensor is installed on the No.4 throttle body.
( 4-38)
TP SENSOR REMOVAL/INSTALLATION
• Lift and support the fuel tank. ( 4-51)
• Remove the TP sensor setting screws 1 and disconnect the
coupler 2.
• Install the TP sensor to the No.4 throttle body. Refer to page 4-
28 for TP sensor setting procedure.
CKP SENSOR INSPECTION
The signal rotor is mounted on the right end of the crankshaft,
and the crankshaft position sensor (Pick-up coil) is installed on
the right side of the middle crankcase. ( 4-35)
CKP SENSOR REMOVAL/INSTALLATION
( 3-23 and -81)
CMP SENSOR INSPECTION
The signal rotor is installed on the intake camshaft, and the cam-
shaft position sensor (Pick-up coil) is installed on the cylinder
head cover. ( 4-34)
CMP SENSOR REMOVAL/INSTALLATION
• Lift and support the fuel tank. ( 4-51)
• Remove the air cleaner box. ( 4-61 and -62)
• Remove the CMP sensor.
Installation is in the reverse order of removal.
IAT SENSOR INSPECTION
The intake air temperature sensor is installed at the right side of
the air cleaner box. ( 4-41)
IAT SENSOR REMOVAL/INSTALLATION
• Lift and support the fuel tank. ( 4-51)
• Disconnect the IAT sensor coupler 1 and remove the IAT sen-
sor from the air cleaner box.
• Installation is in the reverse order of removal.
IAT sensor: 18 N
.
m (1.8 kgf
.
m, 13.0 lb-ft)
To Next Page
Loading...
Need help?
General
