EasyManuals Logo
Home>Suzuki>Motorcycle>GSX-R750K2 2002

Suzuki GSX-R750K2 2002 User Manual

Suzuki GSX-R750K2 2002
495 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
2-30 PERIODIC MAINTENANCE
Overhaul the engine in the following cases:
* Compression pressure in one of the cylinders is less than 900
kPa (9 kg/cm
2
, 128 psi).
* The difference in compression pressure between any two cyl-
inders is more than 200 kPa (2 kgf/cm
2
, 28 psi).
* All compression pressure readings are below 1 100 kPa (11
kgf/cm
2
, 156 psi) even when they measure more than 900 kPa
(9 kgf/cm
2
, 128 psi).
COMPRESSION TEST PROCEDURE
NOTE:
* Before testing the engine for compression pressure, make sure
that the cylinder head nuts are tightened to the specified torque
values and the valves are properly adjusted.
* Have the engine warmed up before testing.
* Make sure that the battery is fully-charged.
Remove the related parts and test the compression pressure in
the following manner.
Lift and support the fuel tank. ( 4-51)
Remove all the spark plugs. ( 2-5)
Install the compression gauge and adaptor in the spark plug
hole. Make sure that the connection is tight.
Keep the throttle grip in the fully opened position.
Press the starter button and crank the engine for a few sec-
onds. Record the maximum gauge reading as the cylinder com-
pression.
Repeat this procedure with the other cylinders.
[[
[[
[ 09915-64510: Compression gauge set
09913-10750: Adaptor
COMPRESSION PRESSURE CHECK
The compression pressure reading of a cylinder is a good indicator of its internal condition.
The decision to overhaul the cylinder is often based on the results of a compression test. Periodic mainte-
nance records kept at your dealership should include compression readings for each maintenance service.
COMPRESSION PRESSURE SPECIFICATION
Standard Limit Difference
1 100 1 500 kPa 900 kPa 200kPa
11 15 kgf/cm
2
9 kgf/cm
2
2 kgf/cm
2
156 213 psi 128 psi 28 psi
Low compression pressure can indicate any of the following conditions:
* Excessively worn cylinder walls
* Worn piston or piston rings
* Piston rings stuck in grooves
* Poor valve seating
* Ruptured or otherwise defective cylinder head gasket

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki GSX-R750K2 2002 and is the answer not in the manual?

Suzuki GSX-R750K2 2002 Specifications

General IconGeneral
BrandSuzuki
ModelGSX-R750K2 2002
CategoryMotorcycle
LanguageEnglish

Related product manuals