4-70 FI SYSTEM AND INTAKE AIR SYSTEM
THROTTLE BODY AND STV ACTUATOR
INSTALLATION
STV ACTUATOR INSTALLATION
• Install the STV actuator bracket 1 to the throttle body.
• Fit the clamp to the bolt A.
• Install the STV actuator to the bracket.
!!
!!
! STV actuator mounting bolt: 5 N
.
m (0.5 kgf
.
m, 3.5 lb-ft)
• Loosen the lock nuts 2 fully.
NOTE:
* No.1 cable and No.2 cable can be distinguished by the letters
“1-35 F” and “2-35F” marked on the outer cable.
* No.2 inner cable is longer than that of No.1 cable.
No.1 Cable
No.2 Cable
No.1 Cable
No.2 Cable
No.1 Cable
No.2 Cable
No.1 Cable
No.2 Cable