ENGINE 3-11
ENGINE INSTALLATION
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
NOTE:
Be careful not to damage the frame and engine when installing
the engine.
• Before installing the engine, install the spacer 1.
• Before installing the engine, install the engine mounting thrust
adjusters 2 and 3.
• Gradually raise the rear side of the engine assembly, and then
put the drive chain on the driveshaft.
• Install all engine mounting bolts, spacers and tighten them
temporarily. ( 3-12)
#
Be careful not to catch the wiring harness between the
frame and the engine.
• Tighten the engine mounting thrust adjusters to the specified
torque.
• Tighten the engine mounting thrust adjuster lock nuts to the
specified torque with the special tool.
!!
!!
! Engine mounting thrust adjuster locknut:
45 N
.
m (4.5 kgf
.
m, 32.5 lb-ft)
• Tighten all engine mounting bolts and nuts to the specified
torque. ( 3-12)
NOTE:
The engine mounting nuts are self-locking. Once the nuts have
been removed, they are no longer of any use.
• Tighten the engine mounting pinch bolt to the specified torque.
( 3-12)
To Next Page
Loading...
Need help?
General
