CHASSIS 6-69
BRAKE PAD REPLACEMENT
• Remove the brake pad cover.
• Remove the clip 1.
• Remove the brake pads along with the shims by removing the
brake pad mounting pins 2 and springs 3.
#
* Do not operate the brake pedal while dismounting the
pads.
* Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
• Install the new brake pads and shims.
#
Be sure to install the shims properly as shown in the
illustration.
NOTE:
After replacing the brake pads, pump the brake pedal few times
to operate the brake correctly and then check the brake fluid level.
BRAKE FLUID REPLACEMENT
• Remove the frame cover. ( 6-8)
• Remove the brake fluid reservoir cap.
• Replace the brake fluid in the same manner as the front brake.
( 6-61)
NN
NN
N Specification and Classification: DOT 4
#
Bleed air from the brake system. (


 2-22)
To Next Page
Loading...
Need help?
General
