Engine Lubrication System: 1E-6
Oil Sump Filter Inspection and Cleaning
B827H11506004
Inspect the oil sump filter in the following procedures:
1) Remove the oil sump filter. Refer to “Oil Sump Filter
Removal and Installation (Page 1E-5)”.
2) If the oil sump filter is clogged with sediment or rust,
clean the oil sump filter using compressed air.
NOTE
When the filter is dirtied excessively, replace
the oil sump filter with a new one.
3) Install the oil sump filter. Refer to “Oil Sump Filter
Removal and Installation (Page 1E-5)”.
Oil Jet Removal and Installation (LT-F400/F)
B827H11506005
Removal
1) Remove the clutch cover. Refer to “Clutch Removal
and Installation (LT-F400/F) in Section 5C (Page 5C-
3)”.
2) Remove the oil jet (1).
Installation
Install the oil jet in the reverse order of removal. Pay
attention to the following points:
• Apply engine oil to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
Oil Jet Inspection (LT-F400/F)
B827H11506006
Refer to “Oil Jet Removal and Installation (LT-F400/F)
(Page 1E-6)”.
Make sure that the oil jet is not clogged. If it is clogged,
clean the oil passage using a wire of the proper size or
compressed air.
Oil Pump Drive Gear / Oil Pump Removal and
Installation
B827H11506007
Removal
NOTE
Be careful not to drop the parts into the
crankcase.
1) Drain the engine oil. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-7)”.
2) Remove the drive V-belt inner cover. (LT-A400/F).
Refer to “Clutch Shoe Removal and Installation in
Section 5A (Page 5A-16)”.
Remove the clutch cover. (LT-F400/F). Refer to
“Clutch Removal and Installation (LT-F400/F) in
Section 5C (Page 5C-3)”.
I827H1150021-01
1
I827H1150010-01
I827H1150011-02
I827H1150012-01
To Next Page
Loading...
Need help?
General
