To Next Page

To Previous Page

6B-11 Steering / Handlebar:

Steering Shaft Holder

Inspect the steering shaft holders for wear or damage. If

any defects are found, replace the steering shaft holders

with new ones.

Steering Shaft Bushing

Inspect the steering shaft bushing for wear or damage. If

any defects are found, replace the steering shaft bushing

with a new one.

Specifications

Service Data (LT-A400/F, LT-F400/F)

B827H16207001

Wheel

Unit: mm (in)

Tightening Torque Specifications

B827H16207002

NOTE

The specified tightening torque is also described in the following.

“Steering / Handlebars Components (Page 6B-1)”

“Steering Assembly Construction (Page 6B-2)”

Reference:

For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A400/F) in

Section 0C (Page 0C-9)”.

I827H1620046-01

I827H1620047-01

Item Standard Limit

Steering angle 47° (right & left) —

Turning radius 3.1 m (10.2 ft) —

Toe-in (with 75 kg, 165 lbs) 10 ± 4 mm (0.39 ± 0.16 in) —

Camber 0.3° —

Caster 3° —

Fastening part

Tightening torque

Note

N⋅mkgf-mlb-ft

Handlebar clamp bolt 26 2.6 19.0 )(Page 6B-4)

Steering shaft holder bolt 23 2.3 16.5 )(Page 6B-8)

Steering shaft lower nut 49 4.9 35.5 )(Page 6B-9)

Tie-rod end nut 29 2.9 21.0 )(Page 6B-9)

Tie-rod lock-nut 29 2.9 21.0 )(Page 6B-9)

Suzuki LT-F400F Service Manual

Other manuals for Suzuki LT-F400F