Clutch: 5C-8
Clutch Wheel
Inspect the clutch wheel for any abnormal surface
damage. Measure the inside diameter of the clutch
wheel. If the measurement exceeds the service limit,
replace the clutch wheel with a new one.
Clutch wheel I.D.
Service limit: 140.5 mm (5.53 in)
One-way Clutch
1) Install the one way clutch (1) into the clutch wheel.
NOTE
When installing the one way clutch (1) into
the clutch wheel, make sure that the “OUT
SIDE” letters “A” on the one-way clutch faces
to the clutch shoe side.
2) Install the clutch shoe (3) onto the clutch wheel and
turn the clutch shoe by hand to inspect the one way
clutch for a smooth movement. The clutch shoe
turns one direction only. If a large resistance is felt to
rotation, inspect the one way clutch for damage or
one-way clutch contacting surface of the clutch shoe
for wear or damage. If any defects are found, replace
them with new ones.
Clutch Cover Disassembly and Assembly (LT-
F400/F)
B827H15306019
Refer to “Clutch Removal and Installation (LT-F400/F)
(Page 5C-3)”.
Disassembly
1) Remove the clutch release mechanism.
I831G1510086-01
“A”
1
I827H1530026-01
2
I827H1510079-01
I827H1530027-01
To Next Page
Need help?
General
