Charging System: 1J-13
Battery Recharging
CAUTION
!
Do not remove the caps on the battery top
while recharging.
NOTE
When the vehicle is not used for a long
period, check the battery every 1 month to
prevent the battery discharge.
1) Remove the battery from the vehicle. Refer to
“Battery Removal and Installation (Page 1J-13)”.
2) Measure the battery voltage using the multi-circuit
tester.
If the voltage reading is less than the 12 V (DC),
recharge the battery with a battery charger.
Recharging time
1.4 A for 5 to 10 hour or 6 A for 1 hour
3) After recharging, wait at least 30 minutes and then
measure the battery voltage using the multi-circuit
tester.
If the battery voltage is less than 12.5 V, recharge
the battery again.
If the battery voltage is still less than 12.5 V after
recharging, replace the battery with a new one.
4) Install the battery to the vehicle. Refer to “Battery
Removal and Installation (Page 1J-13)”.
Battery Removal and Installation
B827H11A06008
Removal
1) Remove the seat. Refer to “Exterior Parts Removal
and Installation in Section 9D (Page 9D-3)”.
2) Remove the battery stay (1).
3) Disconnect the battery (–) lead wire (2).
4) Disconnect the battery (+) lead wire (3).
NOTE
Be sure to disconnect the battery (–) lead
wire (2) first, then disconnect the battery (+)
lead wire (3).
5) Remove the battery (4).
Installation
Install the battery in the reverse order of removal.
Pay attention to following point:
CAUTION
!
Never use anything except the specified
battery.
• Tighten the battery lead wire mounting bolts securely.
Battery Visual Inspection
B827H11A06009
Inspect the battery in the following procedures:
1) Remove the seat. Refer to “Exterior Parts Removal
and Installation in Section 9D (Page 9D-3)”.
2) Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of the battery have occurred, replace the
battery with a new one.
If the battery terminals are found to be coated with
rust or an acidic white powdery substance, clean the
battery terminals with sandpaper.
3) Install the seat.
“A”: Charging period “B”: Stop charging
“A”
“B”
I649G11A0045-02
(V)
(%)
13
10
11
12
14
255075100 0
Battery charged condition
(at 0
°
C
(32 °F
)
–
40
°C (104 °F))
I827H11A0031-02
1
3
4
2
I827H11A0036-01
To Next Page
Loading...
Need help?
General
