Suzuki LT-F400F Service Manual

3B-5 Differential:
6) Remove the front drive (differential) mounting bolts.
7) Remove the transfer cable bracket bolts and
disconnect the transfer cable (2).
8) Remove the front drive (differential) assembly from
the frame.
Installation
Install the front drive (differential) assembly in the
reverse order of removal. Pay attention to the following
points:
• Apply grease to splines and fit the boot firmly.
: Grease 99000–25160 (Water resistance
grease)
NOTE
When engaging the yokes, align each wide
spline tooth “A” of them.
• Connect the transfer cable.
• Apply thread lock to the front drive (differential)
mounting bolts and tighten the nuts to the specified
torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Front drive (differential) gear case mounting nut
(a): 45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Pour the front differential gear oil. Refer to “Front
Differential Gear Oil Inspection (LT-A400F, LT-F400F)
in Section 0B (Page 0B-9)”.
Front Drive (Differential) Assembly
Disassembly and Assembly (LT-A400F, LT-
F400F)
B827H13206006
Refer to “Front Drive (Differential) Assembly Removal
and Installation (LT-A400F, LT-F400F) (Page 3B-4)”.
Disassembly
1) Remove the front drive (differential) case cover bolts
in a crisscross pattern.
I827H1320005-01
2
I827H1320006-01
“A”
I827H1320007-01
(a)
I827H1320008-01
I827H1320009-01

Suzuki LT-F400F Specifications

General

Brand	Suzuki
Model	LT-F400F
Category	Offroad Vehicle
Language	English