9B-4 Lighting Systems:
3) Remove the headlight (3) from the housing.
Installation
Install the headlight in the reverse order of removal. Pay
attention to the following point:
• After installing, be sure to inspect the headlight beam.
Refer to “Headlight Beam Adjustment (Page 9B-4)”.
Headlight Bulb Replacement
B827H19206004
CAUTION
!
• If you touch the bulb with your bare hands,
clean the bulb with a cloth moistened with
alcohol or soapy water to prevent
premature bulb failure.
• Do not use bulb other than those with
predetermined wattage.
• Remove the bulb when it gets cool, since it
may be heated to an extremely high
temperature when the headlight is turned
ON.
1) Remove the headlight housing cover (1).
2) Remove the socket cover (2) and disconnect the
socket (3).
3) Replace the headlight bulb (4) by unhooking the bulb
holder spring (5).
4) Reinstall the removed parts.
NOTE
Properly fit the socket cover and headlight
housing cover.
Headlight Beam Adjustment
B827H19206005
Adjust the headlight vertical beam by turning the screw
in or out.
3
I827H1920007-01
1
2
3
I827H1920008-02
5
4
I827H1920009-01
I827H1920010-01
To Next Page
Loading...
Need help?
General
