1G-23 Fuel System:
Fuel
Tightening Torque Specifications
B827H11707002
NOTE
The specified tightening torque is also described in the following.
“Fuel Tank Construction (Page 1G-12)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A400/F) in
Section 0C (Page 0C-9)”.
Special Tools and Equipment
Recommended Service Material
B827H11708001
NOTE
Required service material is also described in the following.
“Carburetor Components (Page 1G-16)”
Special Tool
B827H11708002
Item Specification Note
Fuel type
Use only unleaded gasoline of at least 87 pump octane (R/2
+ M/2) or 91 octane or higher rated by the Research Method.
Gasoline containing MTBE (Methyl Tertiary Butyl Ether), less
than 10% ethanol, or less than 5% methanol with
appropriate cosolvents and corrosion inhibitor is permissible.
P-28, 33
Gasoline used should be graded 91 octane or higher. An
unleaded gasoline type is recommended.
Others
Fuel tank capacity, including reserve 16.0 L (4.2/3.5 US/lmp gal)
Reserve 2.9 L (0.8/0.7 US/lmp gal)
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Fuel valve bolt 4.6 0.46 3.5 )(Page 1G-14)
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE A or
equivalent
P/No.: 99000–25010 )(Page 1G-20) /
)(Page 1G-20)
09900–20102
Vernier calipers (1/20 mm,
200 mm)
)(Page 1G-21)
To Next Page
Loading...
Need help?
General
