Engine Mechanical: 1D-44
3) Install camshaft journal holder and tighten the
camshaft journal holder bolts in ascending order of
numbers to the specified torque. Refer to “Engine
Top Side Assembly (Page 1D-30)”.
NOTE
Do not rotate the camshafts with the
plastigauge in place.
Tightening torque
Camshaft journal holder bolt: 11 N·m (1.1 kgf-m,
8.0 lb-ft)
4) Remove the camshaft journal holder and measure
the width of the compressed plastigauge using the
envelope scale.
5) This measurement should be taken at the widest
part of the compressed plastigauge.
Camshaft journal oil clearance (IN. & EX.)
Service limit: 0.150 mm (0.0059 in)
6) If the camshaft journal oil clearance exceeds the
limit, measure the inside diameter of the camshaft
journal holder and the outside diameter of the
camshaft journal. Replace the camshaft or the
cylinder head depending upon which one exceeds
the specification.
Special tool
(C): 09900–20602 (Dial gauge (1/1000 mm, 1
mm))
(D): 09900–22403 (Small bore gauge (18 –
35 mm))
Camshaft journal holder I.D. (IN. & EX.)
Standard: 24.012 – 24.025 mm (0.9454 – 0.9459
in)
Special tool
(E): 09900–20205 (Micrometer (0 – 25 mm))
Camshaft journal O.D. (IN. & EX.)
Standard: 23.959 – 23.980 mm (0.9433 – 0.9441
in)
I822H1140118-01
I822H1140119-01
(C)
(D)
I822H1140120-01
(E)
I822H1140121-01
To Next Page
Loading...
Need help?
General
