9B-8 Lighting Systems:
Turn Signal Light Bulb Replacement
B822H19206015
CAUTION
!
When you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
1) Remove the lens (2) by removing the screw (1).
2) Replace the bulb (3).
3) Reinstall the lens.
Turn Signal / Side-stand Relay Inspection
B822H19206017
Refer to “Electrical Components Location in Section 0A
(Page 0A-7)”.
NOTE
Make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are
OK, the turn signal relay may be faulty; therefore,
replace the turn signal/side-stand relay with a new one.
Refer to “Turn Signal / Side-stand Relay Removal and
Installation (Page 9B-8)”.
Turn Signal / Side-stand Relay Removal and
Installation
B822H19206018
Removal
1) Remove the battery holder. Refer to “Battery /
Battery Holder Removal and Installation in Section
1J (Page 1J-11)”.
2) Remove the turn signal/side-stand relay (1).
Installation
Install the turn signal/side-stand relay in the reverse
order of removal.
Hazard Switch Inspection
B822H19206019
Inspect the hazard switch in the following procedures:
1) Remove the headlight assembly. Refer to “Headlight
Removal and Installation (Page 9B-2)”.
2) Disconnect the left handlebar switch coupler (1).
2
1
I822H1920020-01
3
I822H1920021-01
1
I822H1920022-01
1
I822H1920023-02
To Next Page
Loading...
Need help?
General
