Wheels and Tires: 2D-7
Front Wheel Dust Seal / Bearing Removal and
Installation
B822H12406005
Removal
1) Remove the front wheel assembly. Refer to “Front
Wheel Assembly Removal and Installation
(Page 2D-4)”.
2) Remove the dust seals (1).
Special tool
(A): 09913–50121 (Oil seal remover)
3) Remove the bearings (2) using the special tool.
Special tool
(B): 09921–20240 (Bearing remover set)
4) Remove the spacer (3).
Installation
CAUTION
!
The removed dust seals and bearings must
be replaced with new ones.
1) Apply grease to the wheel bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
2) First install the right wheel bearing, then install the
spacer (1) and left wheel bearing with the special
tool.
Special tool
(A): 09941–34513 (Steering race installer)
(B): 09924–84510 (Bearing installer set)
CAUTION
!
The sealed cover of the bearing must face
outside.
(A)
1
I822H1240009-01
(B)
2
I822H1240010-01
3
I822H1240011-01
I649G1240019-02
(A)
(B)
I822H1240012-01
To Next Page
Loading...
Need help?
General
