Steering / Handlebar: 6B-8
If any abnormal points are found, replace defective parts
with new ones.
Steering System Inspection
B822H16206008
Refer to “Steering System Inspection in Section 0B
(Page 0B-22)”.
Steering Stem Bearing Removal and Installation
B822H16206009
Removal
1) Remove the steering stem lower bracket. Refer to
“Steering Removal and Installation (Page 6B-5)”.
2) Remove the dust seal (1) and steering stem upper
bearing (2).
3) Remove the steering stem lower bearing and inner
race using a chisel.
4) Remove the steering stem upper and lower bearing
races using the special tools.
Special tool
(A): 09941–54911 (Bearing outer race
remover)
(B): 09941–74911 (Steering bearing
installer)
Installation
Install the steering stem bearings in the reverse order of
removal. Pay attention to the following points:
CAUTION
!
The removed bearings and races should be
replaced with new ones.
Outer race
• Press in the upper and lower outer races using the
special tool.
Special tool
(A): 09941–34513 (Steering race installer)
I822H1620022-01
I822H1620023-01
1
2
I822H1620024-02
I649G1620033-02
(B)
(A)
I649G1620034-03
(A)
I649G1620035-03
To Next Page
Loading...
Need help?
General
