9C-4 Combination Meter / Fuel Meter / Horn:
Engine Coolant Temperature Indicator Light
Inspection
B822H19306005
Inspect the engine coolant temperature indicator light in
the following procedures:
1) Remove the right air cleaner box. Refer to “Air
Cleaner Element Removal and Installation in Section
1D (Page 1D-6)”.
2) Disconnect the ECT sensor coupler (1).
3) Connect the variable resistor (2) between the
terminals.
4) Turn the ignition switch ON.
5) Check the LED operations when the resistance is
adjusted to the specified values.
If either one or all indications are abnormal, replace
the combination meter with a new one. Refer to
“Combination Meter Removal and Installation
(Page 9C-2)”.
6) Connect the ECT sensor coupler.
Engine Coolant Temperature Removal and
Installation
B822H19306006
Refer to “ECT Sensor Removal and Installation in
Section 1C (Page 1C-3)”.
Fuel Level Indicator Inspection
B822H19306007
Inspect the fuel level indicator in the following
procedures:
1) Support the motorcycle with a jack or wooden block.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
8)”.
3) Disconnect the fuel level gauge coupler (1).
4) Connect variable resistor (2) between the B/Lg and
B/W lead wires from the wire harness.
Resistance
LED
(3)
LCD
(4)
Water temperature
0.11 kΩ and over OFF — 120 °C below
0.11 kΩ and below ON ON 120 °C and over
1
I822H1930028-01
2
I718H1930009-05
4
3
I822H1930006-05
1
I822H1930007-01
2
I822H1930008-02
To Next Page
Loading...
Need help?
General
