EasyManuals Logo
Home>Suzuki>Motorcycle>VLR1800

Suzuki VLR1800 Service Manual

Suzuki VLR1800
624 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #385 background imageLoading...
Page #385 background image
Charging System: 1J-3
Repair Instructions
Battery Current Leakage Inspection
B822H11A06001
Inspect the battery current leakage in the following
procedures:
1) Turn the ignition switch OFF.
2) Remove the seat. Refer to “Exterior Parts Removal
and Installation in Section 9D (Page 9D-3)”.
3) Disconnect the battery (–) lead wire.
4) Measure the current between battery (–) terminal
and the battery (–) lead wire using the multi-circuit
tester. If the reading exceeds the specified value,
leakage is evident.
CAUTION
!
In case of a large current leak, turn the
tester to high range first to avoid tester
damage.
Do not turn the ignition switch to ON
position when measuring current.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Current ( , 20 mA)
Battery current (Leak)
Under 3 mA
5) Connect the battery (–) terminal and install the seat.
Refer to “Battery / Battery Holder Removal and
Installation (Page 1J-11)” and “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
Regulated Voltage Inspection
B822H11A06002
Inspect the regulated voltage in the following
procedures:
1) Remove the seat. Refer to “Exterior Parts Removal
and Installation in Section 9D (Page 9D-3)”.
2) Start the engine and keep it running at 5 000 r/min
with the dimmer switch turned HI position.
3) Measure the DC voltage between the battery (+) and
(–) terminals using the multi-circuit tester. If the
voltage is not within the specified value, inspect the
generator and regulator/rectifier. Refer to “Generator
Inspection (Page 1J-4)” and “Regulator / Rectifier
Inspection (Page 1J-7)”.
NOTE
When making this test, be sure that the
battery is in fully charged condition.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage ( )
Regulated voltage (Charging output)
Standard: 13.5 – 15.5 V at 5 000 r/min
4) Install the seat. Refer to “Exterior Parts Removal and
Installation in Section 9D (Page 9D-3)”.
I649G11A0002-02
(DCV)
Tester
Battery
I649G11A0003-02

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki VLR1800 and is the answer not in the manual?

Suzuki VLR1800 Specifications

General IconGeneral
BrandSuzuki
ModelVLR1800
CategoryMotorcycle
LanguageEnglish

Related product manuals