48 Part C: Basic Tasks © Tait Electronics Limited December 2007
Changing Base Station Mode
Some Service Kit operations can only be carried out when the base station is
not in its normal operating mode.
To change the base station’s operation mode
1. Press F5 to go directly to Standby mode, or F6 for Run mode.
2. Alternatively, click Mode. (Or, select Base Station > Change Mode.) If you
have rights to change mode, the Change Operating Mode dialog box
appears.
3. Select the mode you want.
Q Modes that you don’t have access rights to are disabled.
Q To leave Download mode, reset the base station. The Service Kit
displays the Connecting dialog box. Wait about 10 seconds for the base
station to start up, then re-connect and log on. The base station is now
in Standby mode.
4. Click OK.
Resetting the Base Station
You can reset the base station using the Service Kit.
1. Click Mode.
2. Click Reset Base Station.
3. Wait for the base station to restart, and then connect and log on again.
To Next Page
Loading...
Need help?
General
