Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown above. These controls vary
depending on the search Type. Setting the search conditions is similar to setting the parameters for an Event Trigger.
NOTE. No information will be displayed in this window until you specify at least one search Type in the Search Select Control
Window.
Copy search settings
From the Analyze menu, select Search; then open the Configure tab and press the Copy Settings button.
Overview
Use these controls to copy settings from one search to another. You can also copy a trigger setting to a search.
To use
1. Set up the desired search(s) in the Search - Select window.
2. Set up the parameters for the search in the Search - Configure window.
3. Click the Copy Settings button to open the Copy Settings window.
4. In the From drop-down list box, select the search or trigger you want to copy.
5. In the To drop-down list box, select the search to copy the settings to.
6. Click the Copy button.
What do you want to do next?
Learn about Search Advanced DDR Control Settings.
Analyzing waveforms
302 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series
To Next Page
Loading...
Need help?
General
