You can run all tests or specific tests using the options on the Subsystem, Area, and Text drop-down lists. The Diagnostic Status
table lists each diagnostic, the results of the test, and the number of failures that occurred.
Behavior
This window is mainly intended for service personnel. The diagnostic information can be used as part of an incoming inspection
or to diagnose potential problems with the instrument.
NOTE. Remove the input signals before running any diagnostics.
If any diagnostic failures occur, record the failure information, and then contact your local Tektronix service personnel for more
information.
E-mail on event control window
From the Utilities menu, highlight E-mail on Event; then select Setup.
Overview
Use this control window to set up the conditions under which the instrument will send an e-mail, the types of attachments to
include, and the message limits.
Utilities
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 555
To Next Page
Loading...
Need help?
General
