Behavior
The Display button applies only to the selected waveform. Each waveform (channel, math, or reference) has its own Display
button.
Any displayed channel, math, or reference waveform can be turned off without impacting any math functions, measurements, or
histograms done on that waveform. You may want to turn some waveform displays off to make the remaining waveforms easier
to view and analyze.
TIP. Use the dedicated front-panel buttons to turn the channel waveforms on or off.
What do you want to do next?
Learn more about the Waveform controls.
Set the Position-Offset
From the Vertical or Math menus, select Position/Scale.
To use
Use the Position/Offset control window to set the vertical position and offset of the selected waveform.
1. Use the Channels Selector to select a waveform.
2. Use the Scale and Position controls to set the vertical position and scale of the selected waveform.
3. Use the Offset control to set the vertical offset of the selected waveform.
What do you want to do next?
Learn more about the Vertical Position control.
Learn more about the Vertical Scale control.
Learn more about the Waveform controls.
Learn more about the Vertical controls.
Vertical setups
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 485
To Next Page
Loading...
Need help?
General
