Instrument diagnostics control window
From the Utilities menu, select Instrument Diagnostics.
Overview
Use this control window to run the instrument diagnostics.
The following screen appears on MSO/DPO5000B Series instruments:
To use
1. Use the drop-down list boxes to identify the Subsystem, Area, and Test you want to run.
2. Use the Halt Condition controls to enable looping on the selected test(s) or to halt looping as soon as a failure occurs.
3. Click the Run button to initiate the tests.
The Error Log button displays the number of entries in the error log if the number is greater than 0, else nothing is displayed. The
Diagnostics error Log window is available only when the power up diagnostic setting is set to Factory.
NOTE. The Manual Product Verification option to know how to use special PV modes is available only on MSO/DPO5000B
Series instruments.
Utilities
554 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series
To Next Page
Loading...
Need help?
General
