4. Adjust the Intensity:
a. Open the Display control window Appearance tab.
b. Rotate the front-panel Intensity knob to adjust the intensity of displayed waveforms, or click in the Intensity FastAcq/
WfmDB entry box and enter the intensity value with the keypad or multipurpose knob.
5. Select the Color Palette:
a. Open the Display control window Colors tab.
b. Click a color palette button in the Fast/Acq WfmDB Palette. In Fast Acquisitions mode, Temp and Spectral show more
detail than the other color palettes.
c. For a definition of each color palette, click here.
Display persistence
From the Display menu, select Display Setup; then open the Appearance tab.
To use
Click one of the buttons to select the display persistence.
â–
Click Infinite (persistence) to continuously accumulate record points on the waveform until you change one of the acquisition
display settings.
â–
Click Variable; then click in the Time entry box and use the multipurpose knobs to set the persistence time.
â–
Click Reset to clear the persistence.
â–
Click Controls to activate the Persistence Control window.
Behavior
â–
Use infinite persistence for displaying record points that may occur outside the normal acquisition envelope.
â–
Use Variable to accumulate record points on the waveform for a specified time interval. Each record point decays
independently according to the time interval.
â–
If you click Off, the waveform record points appear for the current acquisition only.
TIP. Use the Display menu Display Persistence submenu or right-click in the graticule and select Display Persistence from
the shortcut menu to directly access the persistence options.
View the analog characteristics of a digital signal
NOTE. iCapture is available only on MSO70000C/DX Series instruments and DPO70000DX Series instruments with option
MSOU installed.
How to ?
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 579
To Next Page
Loading...
Need help?
General
