MP-3000 Controller
90
6. To change the length of time power limit is
active (On):
a. Press F2 key to scroll to Power Time
menu line (standard setting = 48 hours).
b. Press F4 key with cursor in the “POWER
TIME” menu line. An Enter Arrow
appears in the menu line and the previous
time disappears.
c. Enter new active period in hours.
d. With the correct hours entered in the menu
line, press and hold F4 key until cursor
stops flashing. Cursor stops flashing and
new value appears in display.
7. Press ESC key to exit the Power Management
submenu.
Misc. Functions Menu
The Misc. Functions menu displays a list of
functions that identifies trips and determines how
the controller records and displays operating
information. The following functions are
available:
• Date Time: Sets the controller time and date.
• Run Time: Displays and sets operating hours
for the unit and components.
• Program Version: Displays the current
software version loaded in the controller:
Controller (CTRL), EPROM and program
serial numbers (SER NO).
NOTE: The Controller Label on the side of the
control box shows the controller serial number
and the EPROM version.
• Cargo Data: Sets important trip information
about the container and the load in the
controller.
• C/F Mode: Sets the temperature value (Celsius
or Fahrenheit) the controller uses to record
and display temperature (including historical
data).
Viewing the Misc. Functions Menu
With the UNIT ON/OFF switch ON and the LCD
display showing the standard display (setpoint):
1. Press the F3 key to enter the menu list. Press
F2 key to scroll through Main menu until
“MISC. FUNCTIONS” appears in LCD
display.
2. Press F4 key to access the Misc. Functions
menu. The first command in the submenu
appears in the LCD display: Date Time.
3. Press F2 or F3 key to scroll to the desired
function:
•“DATE TIME”
•“C/F MODE”
•“CARGO DATA”
•“PROGRAM VERSION”
•“RUN TIME”
4. Press F4 key to access the function selected.
To Next Page
Loading...
Need help?
General
