Chapter 3 Configuring the Tracer MP580/581
44 CNT-SVP01C-EN
Configuring an SCC or DAC profile
You can set up the Tracer MP580/581 to provide a network interface
according to the Space Comfort Controller (SCC) or Discharge Air Con-
troller (DAC) profile. To implement a one of these profiles, you must com-
plete the following:
• Activate the profile.
• Configure the interface.
• Write a program to implement the configured information. See sam-
ple programs in the Tracer graphical programming library.
To set up an SCC or DAC profile:
1. In the Active Device View, click the Unit tab. The status information
for the controller appears.
2. Click the Configuration button. The Configuration dialog box appears
with the Unit tab displayed (Figure 17 on page 20).
3. Click to select the Activate Profile check box.
4. Click the SCC option to provide a network interface following the
SCC profile or click the DAC option to provide a network interface fol-
lowing the DAC profile.
5. Complete one of the following options:
• Click the SCC or DAC tab to set up the interface. See the follow-
ing sections for more information on configuring the interface.
• Click the Download button to send your changes to the Tracer
MP580/581 and click Close to close the Configuration dialog box
Configuring the SCC interface
To set the configuration parameters associated with the SCC profile:
1. In the Active Device View, click the Configuration button. The Config-
uration dialog box appears.
2. Click the SCC tab. The SCC configuration information appears
(Figure 32).
Note:
This tab is available only when the SCC profile is active in the
Tracer MP580/581.
To Next Page
Loading...
Need help?
General
