CNT-SVP01C-EN 65
Chapter 5
Using the Calculations
application
If there is a Tracer Summit system on the active link, use its totalization
application to totalize pulse accumulations. If there is no Tracer Summit
system on the active link, the Tracer MP580/581 plug-in includes the Cal-
culations application that you can use to totalize pulse accumulations.
This application is easy to set up and apply to electrical monitoring, fluid
flow, and other metering and monitoring functions. It can also be used to
calculate runtime and starts for equipment. You do not have to do custom
programming to calculate runtime. You can run up to six calculations.
Use this application only for non-billing purposes.
Viewing the status of a calculation
In the Rover service tool, view the status of a calculation, including its
name, type, current value, and units. You can also view the accumulated
values for the calculation.
To view the status of a calculation:
X In the Active Device View, click the Application tab. The status of the
Tracer MP580/581 applications appears (Figure 41 on page 66).
To Next Page
Loading...
Need help?
General
