Triumph SPEED TWIN 1955 User Manual

Ty res
Removing
the First Bead. Insert a lever AT THE VALVE POSITION and while
I
pulling on chis lever, press the bead into the well of the rim diametrically opposite
I
the valve position. Insert a second lever close to the first and prlse the bead over
I
the rim flange. Remove the first lever and re-insert a little further away from the
second lever. Continue round the bead in steps of
2-3 ~nches (5 to 8 cms.) until the
i
bead is away from the rim.
Inner Tube. Push the valve out of the rim and remove the inner tube.
Removing the Second Bead. Stand the wheel upright and insert a lever between
the'remaining bead and the rim. Pull the cover away from the rim.
FITTING THE TYRE
Rim Band. Make sure that the rough side of the rubber rim band
is fitted against
the rim and that the band
is central in the weii.
Fig. 56. IL~USTRATION SHOWING THE POSITION OF THE VALVE
IF
THE TYRE HAS CREPT ROUND ON THE RIM

Triumph SPEED TWIN 1955 Specifications

General

Brand	Triumph
Model	SPEED TWIN 1955
Category	Motorcycle
Language	English