Xerox Phaser 6000 Service Manual

3-90 Xerox Internal Use Only Phaser 6000/6010 and WC 6015 MFP
Error Messages and Codes
Rear Cover Open
A Rear Cover Open error was detected.
Applicable Error
• 077-304: Rear Cover Open
Initial Actions
• Open and close the Rear Door.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Rear Door, PL1.1.6
■ Interlock Switch, PL1.1.12
■ LVPS, PL7.2.1
■ MCU Board, PL7.2.2
■ “Map 3 - Phaser 6000/6010” on
page 10-9
■ “Phaser 6000/6010 LVPS” on
page 10-11
■ “Map 3 - WorkCentre 6015 MFP” on
page 10-23
■ “WorkCentre 6015 MFP LVPS” on
page 10-25
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Visually inspect the Rear Door for
damage.
Is the Rear Door damaged?
Replace the
Rear Door (for
Phaser
6000/6010, or
page 8-24 for
WorkCentre
6015 MFP).
Go step 2.
2 Enter diagnostic mode and run the
Cover Open Sensor test (see
page 4-11).
Does the number on the display
increase by 1 each time the door is
opened?.
Go to step 4. Go to step 3.
3 Replace the Interlock Switch
(page 8-17 for Phaser 6000/6010, or
page 8-26 for WorkCentre 6015
MFP)?
Does the error persist?
Go to step 4. Complete.

Xerox Phaser 6000 Specifications

General

Brand	Xerox
Model	Phaser 6000
Category	Printer
Language	English