Xerox Phaser 6000 Service Manual

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 3-73
Error Messages and Codes
Deve Mode Change Failure
Applicable Error
• 042-372: Deve Mode Change Failure
Initial Actions
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the connections between the
FAN and LVPS.
Is P/J205 on the LVPS securely
connected?
Go to step 2. Reconnect
connector
P/J205, then
go to step 2.
2 Does the error persist? Go to step 3. Complete.
3 Disconnect P/J205 on the LVPS.
Is the voltage across ground at
P/J205-1 approximately +24 VDC
when the Interlock Switch is pushed?
Go to step 4. Replace the
LVPS.
4 For the 6010N:
Test the Fan (see “Using Phaser
6010N and WorkCentre 6015 MFP
Service Diagnostics” on page 4-10).
For the 6000:
Test the Fan with the CE Diags Tool
(see page A-16).
Does the Fan function normally?
Complete. Replace the
MCU Board
(page 8-121).
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Feed Solenoid, PL6.1.10
■ Switching Sensor
■ Harness Assembly RKN SNS
PL2.2.25/26
■ Developer Drive Assembly, PL6.1.6
■ MCU Board, PL7.2.2
■ “Map 3 - Phaser 6000/6010” on
page 10-9
■ “Phaser 6000/6010 Feeder” on
page 10-12
■ “Map 3 - WorkCentre 6015 MFP” on
page 10-23
■ “WorkCentre 6015 MFP Feeder” on
page 10-26

Xerox Phaser 6000 Specifications

General

Brand	Xerox
Model	Phaser 6000
Category	Printer
Language	English