Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 7-3
Cleaning and Maintenance
Cleaning
Cleaning the LED Windows
If prints have voids or light streaks through one or more colors, use the following
instructions to clean the LED windows.
Do not use warm water or cleaning solvents to remove toner from your skin or
clothing. Warm water sets the toner and makes it difficult to remove. If toner
gets on your skin or clothing, brush it off, blow it off, or wash it off with cold
water and mild soap.
1. Make sure that the printer is turned off and the power cord is unplugged.
2. Spread some paper at the right side of the printer to catch loose toner.
3. Open the toner access cover.
4. Pinch the Toner Cartridge release lever upward, as shown in the illustration.
5. Pull out the Toner Cartridge and set it on the paper with the label side down to
prevent spillage.
6. Remove the other 3 cartridges.
To Next Page
Loading...
Need help?
General