Xerox Phaser 6000 Service Manual

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 3-93
Error Messages and Codes
Registration Jam
Paper remaining at the registration section of the printer was detected.
Applicable Error
• 077-901: Remain Registration Jam
Initial Actions
• Check the media path for obstructions or debris.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Registration Sensor, PL2.3.5
■ Harness Assembly RKN SNS,
PL2.2.25
■ MCU Board, PL7.2.2
■ “Map 2 - Phaser 6000/6010” on
page 10-8
■ “Phaser 6000/6010 Feeder” on
page 10-12
■ “Map 2 - WorkCentre 6015 MFP” on
page 10-22
■ “WorkCentre 6015 MFP Feeder” on
page 10-26
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check connectors P/J12 on the MCU
Board and P/J120 on the
Registration Sensor.
Are the connections secure?
Go to step 3. Secure the
connectors,
then go to
step 2.
2 Does the error persist? Go to step 3. Complete.
3 Enter diagnostic mode and run the
Regi Sensor test (see page 4-24).
You can also use the CE Diag Tool to
run this test (see page A-16).
Lift the Main Paper Tray Chute
(PL3.3.3).
Does the Regi Sensor test pass?
Replace the
MCU Board
(page 8-121)
then go to
step 4.
Go to step 5.
4 Does the error persist? Go to step 5. Complete.
5 Disconnect the MCU Board P/J12.
Is the voltage across ground and
J12-1 +3.3VDC?
Replace the
Registration
Sensor
(page 8-65).
Replace the
MCU Board
(page 8-121).

Xerox Phaser 6000 Specifications

General

Brand	Xerox
Model	Phaser 6000
Category	Printer
Language	English