13 / 184
1. Vehicle information
Know Before Service
1. Use good quality tools, or special tools and fixtures designed by our company. The use of inferior tools may cause
damage to parts, peeling of plating, improper assembly, etc.
2. The O-rings, paper gaskets, copper gaskets, and component sealing rings used for sealing must be replaced before
assembling.
3. Fasteners with torque requirements need to use a torque wrench to check the torque; if the torque is not required,
refer to the general torque value recommended by general fasteners.
4. Clean up before assembly; after assembly, check whether the assembly is correct and in place.
5. The vehicle should be parked balanced and pay attention to safety during disassembly and assembly. Including but
not limited to the use of electric tools, hand tools, pneumatic tools, hydraulic tools, handling; prevent contact with skin,
eyes, burns, etc.
6. The replaced oils, liquids, batteries, etc. must be recycled and handed over to qualified institutions for disposal; it is
forbidden to dump them at will to pollute the environment or water sources.
7. Swallowing or inhaling coolant, brake fluid, etc. will cause certain harm to the human body. Any exposed skin such
as hands and face should be cleaned thoroughly after each addition. If swallowed by mistake, immediately contact the
poison control center or hospital; if inhaled, please immediately go to a ventilated environment. If it accidentally
splashes into the eyes, immediately rinse the eyes with a large amount of running water and seek medical advice or
consultation in time. Keep away from children and pets.
Only part of the basic requirements for matters needing attention, prevention of accidental injury, etc. can be listed;
it is not possible to list all situations in detail. Be vigilant during disassembly and assembly to prevent accidents.
To Next Page
Loading...
Need help?
General
