EasyManuals Logo

Zontes ZT310T-M User Manual

Zontes ZT310T-M
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
149 / 184
10. Front fork assembly
Know Before Service
1. Use good quality tools, or special tools and fixtures designed by our company. The use of inferior tools may cause
damage to parts, peeling of plating, improper assembly, etc.
2. The O-rings, paper gaskets, copper gaskets, and component seals used for sealing must be replaced before
assembly.
3. Fasteners with torque requirements need to use a torque wrench to check the torque; if the torque is not required,
refer to the general torque value recommended by general fasteners.
4. Clean up before assembly; after assembly, check whether the assembly is correct and in place.
5. The vehicle should be parked in a balanced manner and pay attention to safety during disassembly and assembly.
Including but not limited to the use of electric tools, hand tools, pneumatic tools, hydraulic tools, handling; prevent
contact with skin, eyes, burns, etc.
6. The replaced oils, liquids, batteries, etc. must be recycled and handed over to a qualified organization for disposal;
it is forbidden to dump them at will to pollute the environment or water sources.
7. Swallowing or inhaling coolant, brake fluid, etc. will cause certain harm to the human body. Any exposed skin such
as hands and face should be cleaned thoroughly after each addition. If swallowed by mistake, immediately contact the
poison control center or hospital; if inhaled, immediately go to a ventilated environment. If it accidentally splashes into
the eyes, immediately rinse the eyes with a large amount of running water and seek medical advice or consultation in
time. Keep away from children and pets.
8. When replacing the front wheels, jacks or similar devices are needed to support the entire vehicle.
9. Contaminated disc brake discs and disc brake pads will reduce the braking effect. Please replace with new disc
brake discs and clean the contaminated brake discs.
10. When the front wheel is removed, please do not operate the brake handle.
11. After the front wheel is installed, please press the brake handle repeatedly until the brake restores the braking
effect.
Only part of the basic requirements for matters needing attention, prevention of accidental injury, etc. can be listed;
it is not possible to list all situations in detail. Be vigilant during disassembly and assembly to prevent accidents.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zontes ZT310T-M and is the answer not in the manual?

Zontes ZT310T-M Specifications

General IconGeneral
BrandZontes
ModelZT310T-M
CategoryMotorcycle
LanguageEnglish

Related product manuals