183 / 184
main wiring harness of the battery to open the tank lock
or open the tank lock before removing the battery;
Remove the M6x12 boltâ‘· fixing the oil tank cover with
the 4# inner hexagon, and unscrew the threaded oil tank
c. Find out and unplug the tank lock connector under
the cushion stand and make the tank lock wire harness
well.
d. Remove the oil tank cover; Press the cushion
bracket with one hand and take out the middle of the
tank cover plate with the other hand.
Caution: When taking out the middle part of the tank
cover plate, it is necessary to pay attention to the wiring
harness of the tank lock, so as not to get stuck and
avoid pulling the wiring harness of the tank lock; to
prevent dirt matters from entering the tank, immediately
screw the tank cover back to the tank after removing the
middle cover.
Disassembly the left and right
storage boxes
a. Press the switch indicated by the small arrow to
open the front right storage box; Use 4# inner hexagon
to remove 3 M6x16 bolts⑴, and remove bushing⑵ and
buffer glue⑶. Caution: Only the upper 2 bolts have
bushing + buffer glue, while the lower bolts do not have
bushing + buffer glue;Remove 1 nail of the front right
storage box with the 4# inner hexagon, finally remove
the front right storage box.
b. There are three ways to open the front left storage
box :1. Before removing the battery, press the switch
next to the front right storage box switch to open it .2,
Use the battery to connect the positive and negative
terminals of the vehicle to make the vehicle start up,
press the switch next to the front right storage box
switch to open it .3. Find out the front left storage box
switch next to the tap lock or behind the front left
storage box ,and pull out the protruding part of the
switch according to the direction of the arrow to the
outside .
c. Remove 3 M6x16 boltsâ‘´ on the front left storage
box with a 4# inner hexagon , remove the bushing and
buffer glue;Caution: only the upper 2 bolts have
bushing + buffer glue, and the bottom 1 bolt does not
have bushing⑵ + buffer glue⑶.Remove the 1 nail
securing the front left storage box with a 4# inner
hexagon.
d. Remove the front left storage box to the
appropriate position, unplug the USB connector of the
front left storage box, and remove the front left storage
To Next Page
Loading...
Need help?
General
