EasyManuals Logo

Zontes ZT310T-M User Manual

Zontes ZT310T-M
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #93 background imageLoading...
Page #93 background image
93 / 184
Error code
Caution:
●Unlock the vehicle and turn on the flameout switch. When it is not started, the EFI fault light is always on as normal.
If it is not on, the vehicle cannot be started.
●After starting the vehicle, if the fault light is on and the EFI failure is reported, it means that the EFI system is
abnormal.
●When the EFI system reports a failure, continuing to drive the vehicle may cause damage. Please contact a qualified
maintenance organization or our special maintenance point for troubleshooting in time.
1. Read the fault code through the meter
When the engine is running, if the EFI failure
indicator light "" is on, it indicates that there is a fault in
the EFI component that needs to be rectified.
a. Turn the throttle to the maximum before
energizing the whole vehicle, and keep it in the fully
open position, then turn on the electric door lock and
flameout switch. The system detects a fault and the
fault light will start to flash.
b. The fault code has 4 digits. Read the fault code
according to the number of flashes. For example:
P0201 flashes in the following way: continuous
flashing 10 times-intermittent 1 second-continuous
flashing 2 times-intermittent 1 second-continuous
flashing 10 times-intermittent second- Flashes once in
a row.
c. If there is more than one fault, the next fault code
will flash after the fault light is off for 4 seconds.
Therefore, after the fault light is off during the flashing
process, waiting for more than 5 seconds and still no
longer lights up, it means that the fault code has been
flashed.
d. If you need to observe the blinking code again,
you need to turn off the flameout switch first, then turn
it on again, and keep the throttle fully open.
2. Read the fault code through the diagnostic tool
Open the right storage box cover, insert the buckle
with your fingernail or a thin flat-blade screwdriver,
press in and pull out the buckles on both sides at the
same time, then remove the right storage box cover
.
Pull out the OBD plug, connect the diagnostic tool to
read the fault code

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zontes ZT310T-M and is the answer not in the manual?

Zontes ZT310T-M Specifications

General IconGeneral
BrandZontes
ModelZT310T-M
CategoryMotorcycle
LanguageEnglish

Related product manuals